Reef Angel Forum

Thanks. I will have to think about it some. Taking it offline to send it in will require some work. If I get some free time to find and set up the individual controls for my wavemakers, I think I can keep everything in going without the controller for a short time.

The code is posted above, but it is a bit hard to decipher with all of the color codes. I can try to use the copy code for forum option but I can try to post it using a different means if it helps. However, I tried using the reefangel wizard to make a new code. With this new code I still get the sam...

I am not sure what you mean by what board do I have selected (I am VERY novice) :oops: I think I also tried a bit older code and got the same error, but I don't quite remember. Plus the older code was Very similar. I will try something completely different and see if it does it with that as well. I ...

As it is starting to get cold here and I have changed the temps that my aquarium runs at, I pulled up the code I have been running to adjust the temp my heater turns on and off. I ran the verify function and everything seemed fine. However, when I try to upload the code to the actual controller I ge...

Hello, I have a reef angel plus unit. About a year old. When you go to the menu it automatically starts scrolling and will not stop. It makes it real frustrating trying to select something. This also makes it so the display will not turn off. I have messed with it a little and can't seem to get it t...

Sorry for the likely dumb question. I am trying to setup my new wifi attachment. When I open the wifi utility and try to select a serial port and I get an error message "ERROR: connecting to /dev/tty.usbserial-A702865R Additional installation required to use serial, read the console below"...

Great, thanks!!

Around June I set up a program with 2 DC wavemakers. I used a code on here suggested for an else mode. Today I opened Arduino because I wanted to change my on/off temp for my heater. When I first opened up the program it asked me to update the libraries so I did. When I went to compile the same prog...

Still can't get it figured out. It will run through the program but not repeat the next day. Any one have any ideas. Thanks!

OK, so after I uploaded the program is seemed to run through everything great the first day, but then just seemed to stay on the last stage and not start over again the next day. Any Idea? Instead of just an else at the end to I need to specify the specific time? Here is the full code I used. #inclu...

Thanks! You read it how I was hoping it would go. The pumps are moving. I don't know if they are doing what I want them to but they are moving

Matt

Hello, After using the RA+ wizard, I have my two WP40s working pretty well. However, I really want to be able to change programs throughout the day. After reading several threads and using the wizard to generate the bulk of the code I have came up with this. Does it look ok? I wasn't sure if you can...

Hello, everyone. Sorry for some basic questions. I am still trying to get the hang of everything. I was wondering if there is a description of all of the prebuilt programs for the DC wavemakers in the RA wizard somewhere? I tried to search a couple of different terms but wasn't very successful. Also...