Reef Angel Forum

Mine does this with the cable that I got with it and my date is 34 four years off. Relays saying off are really on.

New power supply and drivers worked. Lit right up. Now if I can figure out how to use ato ports to dim

So a meanwell nes 100 or 150 should work 48v cause that's what he sent. Should amp output matter on them cause there higher than the supply he sent I want to have enough power and not question that aspect but don't want fry anything. Thank you for all your help

So I don't know much about the LEDs but I was looking at the new 180 48 from mean well. I was wondering if this would work. Will only be powering 2 Ldds for now. Would this be too much Also if I were to get a four up board and only used two places for the Ldds would that work or would I have to get ...

They are 5v pwm

It's so frustrating. If I hook up one channel now string of 12 they are very dim before they were blinding. But if I hook up one side string of six they blink blinding bright

Nope. Just makes em blink.

I might be able to. I need to know more about the led strings to order another and if it's bad. But I believe it may be

LEDs were wired. Think that's a miss print on board. Left sides are + rights are - only way they light on single strings Even with no LEDs power supply trips hooked up. I know for sure one ldd is junk. Yea. White and bare is power supply. I tried individual strings on both Ldds when they where good....

The wiring of the power supply confuses me cause white should be neutral but it just trips power supply and beeps. Wired this way they blink

Left side. Try get better ones. But the wires between the arrays are opposite the hookup wires.

Right side.

It's puts out what it advertises. What is a good pic uploading site

How do u test for a bad power supply.

They blink. I will when get home. I took resisters off back of board so drivers should light at 100 percent too and they blink

No. It was used. I emailed him for stats on the LEDs Looks like six blues on each array five whites a lime and maybe missing some. Two arrays. He sent two mean well 700ldd h on a driver board and a mew well power supply. Supply is mad 90 watts 48v and like 1.6 amps. When I hook it up the power suppl...

I recently bought some v2 led arrays from Dave at nanobox two ldd700 drivers on a board and a 90w 48v power supply. I tried to code my ato to dim so that I only put 5v to the Ldds. When it's all hooked up the LEDs just blink or flash. Never dim nothing just blink. So I hooked it up to my pwm dimmers...

Do it matter where u put it in the setup and loop. And this all I would need to make it work.

I have some ldd drivers I want to hook to my ato port like above. I was wondering about code to slowly dim them up and down for sunrise and set. I new to all this so I don't know much and need help