Reef Angel Forum

YES!!!!!!!It will be done!!!!Perfect!! You are the BIG ONE Roberto!!! Thanks.

Today arive the new LCD screen (Robeto send me one)! I put them on the RA board and i plug it in the power. But steel the LCD was White .... Is it polsibole the problem comes from RA board???

Τhanks Roberto! I send you PM for details about the screen!

I see "255".What means that?Also the LCD it remains white.

If we disconnect the memory batery and reconnected, sould be work?

RA

I have the PWM.

Is it posible to hapen that: Why doesn't my sketch start when I power up or reset the Arduino board? Most likely because you are sending serial data to the board when it firsts turns on. During the first few seconds, the bootloader (a program pre-burned onto the chip on the board) listens for the co...

Nothing...

How can i chek the LCD screen? Is it possible that it didn't upload all the files the first time and stuk? If yes, can i reboot the head unit and how?
Also Ι conect the head unit with rellay box and i hear to open and close the rellay (probably works OK)!!

I dont know if working. I have not conect the head unit with relay box yet. I haw the RA disconected for 3-4 months and yesterday i try to upload ( with USB power cable) the preloaded code. from tha moment the LCD sceen is white and some times looks like has color pixels.

Yes it was! Now sow me that the code uploaded but LCD is White after uploading. What is the step to reboot the head unit?

I do, but nothing, do not upload the code. I try from second PC, upload the code but steel the LCD is dead- white (some time have color dot).

ΗΙ!! Τoday, after 3 months (the RA it was out of work) i try to upload the preloaded code. After the uploading the RA looks dont work and the LCD is White. I must say tha i give power to the head unit whith the cable and not with relay box. Any ideas???

ok!!!Thanks Roberto!

How can i see that? I order my RA Noveber 2012.

Roberto if i want change the actinic port from 0-10 to PWM and oposite what must do or remove?

Ok! I understand!!!!Thanks

And something else. Τhe PWM led driver work with analog signal and the opposite??

Hi again! If my diming port output voltage are 1-10V (during the port operation) then my RA is analog signal?
And if is 10V (during the port operation) stabilization then my RA is PWM?

Ιf I by dimming expansion module i will need and dimmable led driver, or the module work like led driver?

Οκ i try it!

void setup() { // This must be the first line ReefAngel.Init(); //Initialize controller ReefAngel.SetTemperatureUnit( Celsius ); // set to Celsius Temperature // Ports toggled in Feeding Mode ReefAngel.FeedingModePorts = 0; // Ports toggled in Water Change Mode ReefAngel.WaterChangePorts = Port1Bit ...

Roberto! Today i use controller testter code in my RA and my led dimming normal (sun rise)! BUT... with Wizard code doesn't work why? Is that a bug?

I send mail to the Mean Well. We will see..... Thanks!!

I check the driver with AA 1,5 V and 9V batteries and again the same voltage to the led (11,7) V.

At 0% the AP out put 0,3 V and the led driver 2,6 V. At 100% the AP out put 9,8 V and the led driver 11,8 V. I don't try potentiometer or AA batteries . Is the second led driver with this problem . What I am doing wrong ?

I hope to be clear the diagram.