Page 1 of 1
Re: Help Getting started again.
Posted: Fri Sep 16, 2016 11:48 am
by Sacohen
I have tried that too.
Re: Help Getting started again.
Posted: Fri Sep 16, 2016 11:49 am
by rimai
Can you post the entire error log?
Re: Help Getting started again.
Posted: Fri Sep 16, 2016 5:01 pm
by Sacohen
I can't.
It is too large...
Your message contains 137874 characters. The maximum number of allowed characters is 100000.
Re: Help Getting started again.
Posted: Fri Sep 16, 2016 7:17 pm
by rimai
Save in a text file and attach
Re: Help Getting started again.
Posted: Fri Sep 16, 2016 8:20 pm
by Sacohen
The sketch is in /Users/Steves-iMac/Documents/Arduino and the only other error besides the attached is the "error compiling" in the orange bar between the sketch and the error log.
Re: Help Getting started again.
Posted: Fri Sep 16, 2016 11:57 pm
by rimai
Do you have RA Plus selected as board?
In the log you sent it says this "-mmcu=atmega328p ", which is the wrong chip. Standard RA used 328, but RA+ uses 2560.
Can you also post your code?
Re: Help Getting started again.
Posted: Sat Sep 17, 2016 5:24 am
by Sacohen
That did it.
I was stupid enough to follow the instructions for setting up the software for the MAC which said to set the controller to Reef Angel Controller w/ optiboot.
It's working fine now and the BlueTooth connection worked fine 1st shot.
Re: Help Getting started again.
Posted: Sat Sep 17, 2016 7:22 am
by lnevo
sweet!
Re: Help Getting started again.
Posted: Sat Sep 17, 2016 7:25 am
by Sacohen
Yep.
Stupid mistake on my part.
Thanks for your help Lnevo and Rimai.
Sorry about the wasted time.☹
Sent from my SM-G928P using Tapatalk