Reef Angel Forum

Posted: **Mon Jul 07, 2014 11:23 am**

I recently did not put my new halide bulb in correctly on one side and it did not fire up for a week.

I am curious if there is a way to code my reef angel to tell me if there is a completed circuit on the relay for the halide? Or some way to tell if the halide truly fired?

Thanks in advance,

caliman

Posted: **Mon Jul 07, 2014 11:36 am**

No way to know...however there is a new PAR sensor and jsclownfish (sp?) made a DIY light sensor that could help.

Posted: **Mon Jul 07, 2014 11:49 am**

Oh I'll look into those. Thanks!

Posted: **Mon Jul 07, 2014 2:41 pm**

ReefCam!

--Colin

Posted: **Mon Jul 07, 2014 3:12 pm**

cosmith71 wrote:ReefCam!

--Colin

Good point..

Reef Angel Forum

A way to tell if my halide lamp fired up?

A way to tell if my halide lamp fired up?

Re: A way to tell if my halide lamp fired up?

Re: A way to tell if my halide lamp fired up?

Re: A way to tell if my halide lamp fired up?

Re: A way to tell if my halide lamp fired up?