CO2Control - Relay on and Off all the time
Posted: Thu Jun 22, 2017 10:40 am
Hi there
I use the code ReefAngel.CO2Control(Port1,620,650); to control a solenoid valve attached to a CO2 cilinder.
The problem is that the PH reading fluctuat a little bit, so the Port1 relay keep's getting On and Off in matter of seconds. I am afraid it can damage the solenoid valve.
Is there a way to prevent that from happening? I dont know.. maybe after X seconds above 650 just then get relay On.
Best regards
Rafa
I use the code ReefAngel.CO2Control(Port1,620,650); to control a solenoid valve attached to a CO2 cilinder.
The problem is that the PH reading fluctuat a little bit, so the Port1 relay keep's getting On and Off in matter of seconds. I am afraid it can damage the solenoid valve.
Is there a way to prevent that from happening? I dont know.. maybe after X seconds above 650 just then get relay On.
Best regards
Rafa