I was able to install the RA yesterday without any problems, then I got the code ready to upload and I got the "USB device not recognized" error. I have tried unplugging and replugging the RA with no luck.
What could be the issue/fix?
I have a RA plus v1.0.7
I am running Windows 8.0
Thanks in advance, Chris
HELP usb device not recognized
7 posts
• Page 1 of 1
45g corner, 90g main, 90g staging, 25g frag, working on a 180g setup.
|
|
Try using another USB port
Roberto.
|
|
I tried all 4 USB ports, and realized that i had misread the error.
"the last device you connected to this computer malfunctioned, and windows does not recognize it" the other ports same thing. 45g corner, 90g main, 90g staging, 25g frag, working on a 180g setup.
|
|
So after leaving it unplugged from the usb for 5 min, I plugged it back in and it worked.
45g corner, 90g main, 90g staging, 25g frag, working on a 180g setup.
|
|
here we go again, same error but leaving it unplugged for hours, days, weeks didnt fix it.
What can I do when windows (8) doesnt recognize the device and the port link under tools is greyed out? 45g corner, 90g main, 90g staging, 25g frag, working on a 180g setup.
|
|
here is the error I am getting when I plug in
45g corner, 90g main, 90g staging, 25g frag, working on a 180g setup.
|
|
Bad cable?
|
|
7 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests