Page 1 of 1

Re: Carbon Vodka Dosing

Posted: Sat Nov 22, 2014 11:41 am
by Paul_Velasco
This vodka dosing is awesome. Just wanted to show off tank, controller, and doser.

(removed pictures,will resize later)

Re: Carbon Vodka Dosing

Posted: Sat Nov 22, 2014 12:45 pm
by lnevo
Just change the offset to 8hours and keep repeat 24 hours

DosingPumpRepeat(Box1_Port6,480,1440,660);

Re: Carbon Vodka Dosing

Posted: Sat Nov 22, 2014 2:10 pm
by mudcat1
Paul_Velasco wrote:I want to turn it on at 8 AM and bolus dose the vodka for 11 minutes. How would I tell the DosingPumpRepeat to do the dose at 8AM? That was the only way I could figure it out.
Try this

if (hour() ==8 && minute() == 00) { // At 8:00 am
ReefAngel.DosingPumpRepeat(Box1_Port6,0,0,660); // Dose Vodka for 11 minutes (660 seconds).
}

Re: Carbon Vodka Dosing

Posted: Sat Nov 22, 2014 4:12 pm
by Paul_Velasco
lnevo wrote:Just change the offset to 8hours and keep repeat 24 hours

DosingPumpRepeat(Box1_Port6,480,1440,660);
Ahh so the offset is from midnight, 00? Mudcat1 will try yours as well

How does the vinegar dosing part look? Only dose during lights on

Re: Carbon Vodka Dosing

Posted: Sat Nov 22, 2014 4:13 pm
by lnevo
Mudcat's wont work. It will only work the first minute. The vinegar one looked fine.

Re: Carbon Vodka Dosing

Posted: Mon Nov 24, 2014 8:49 am
by Paul_Velasco
The doser did not turn on today? Any thoughts?
Vinegar dosing relay is the last blue graph

Code: Select all

///Code to make Vinegar Dosing Work 4 mins 
  ReefAngel.DosingPumpRepeat(Box1_Port8,0,60,240);
///Do not turn on Vinegar if lights are off
  if (hour()<=9 || hour()>21) {
    ReefAngel.Relay.Off(Box1_Port8);
  }  

Re: Carbon Vodka Dosing

Posted: Mon Nov 24, 2014 11:57 am
by Paul_Velasco
It turned on at Noon?

Instead of this code:

ReefAngel.DosingPumpRepeat(Box1_Port8,0,60,240);

Should it be this code:

ReefAngel.DosingPumpRepeat(Box1_Port8,540,60,240);

Turn on at 9AM?

What is the math on DosingPumpRepeat? Thought the reset was at midnight (00)?

Re: Carbon Vodka Dosing

Posted: Mon Nov 24, 2014 3:20 pm
by mudcat1
You will have to watch the dosing pump to see if it starts and runs at the desired time. I was told that if the relay is not running for at least 5 minutes it may not show up in the charts on the portal. At least that is what I have encountered when I run my dosing pumps for 140 seconds. Sometimes they show up in the charts sometimes they don't.

Re: Carbon Vodka Dosing

Posted: Mon Nov 24, 2014 4:40 pm
by lnevo
The first arg is the port, second is the offset from midnight. 3rd is runtime and last is the repeat time. As mudcat said the portal only gets updates every 5 minutes starting at last reboot. Sometimes that might capture your dosing pump, sometimes not.

Re: Carbon Vodka Dosing

Posted: Mon Nov 24, 2014 7:48 pm
by Paul_Velasco
Ok will watch tomorrow morning

Re: Carbon Vodka Dosing

Posted: Wed Nov 26, 2014 1:39 pm
by Paul_Velasco
Starting at 2PM want to start at 9AM? Having the portal send me an email everytime the relay triggers. Emails start at 2PM.
Any ideas?

Re: Carbon Vodka Dosing

Posted: Wed Nov 26, 2014 4:57 pm
by lnevo
Again the portal cannot send you reliable notifications like that. Your best method would be to use WiFiAlert to send an alert immediately. Are you using the first or second line that you posted above? I would recommend the second if you want it to start at 9am.

Re: Carbon Vodka Dosing

Posted: Thu Nov 27, 2014 8:39 am
by cosmith71
Here's a way you can track it. This is for 2 pumps. The way this works is when your dosing pump relays come on, this turns on relays in a "ghost" expansion relay for 5 minutes so the portal can track them. It is only good for seeing that the relays came on, not for the actual length of time they were on.

Put this up top in the globals section:

Code: Select all

unsigned long LastUpdate1=0;    // For virtual dosing pumps
unsigned long LastUpdate2=0;    // For virtual dosing pumps
This goes in loop:

Code: Select all

// *******************  Turn on imaginary relays for 5 minutes when dosing pumps activate so Portal can track them  *******************
  if (ReefAngel.Relay.Status(AlkPump) && LastUpdate1==0)
  {
    LastUpdate1 = now();
    ReefAngel.Relay.On (VirtAlk);
  }
  if (now() - LastUpdate1 >= 300 && LastUpdate1 != 0)
  {
    LastUpdate1 = 0;
    ReefAngel.Relay.Off (VirtAlk);
  }
  if (ReefAngel.Relay.Status(CalPump) && LastUpdate2==0)
  {
    LastUpdate2 = now();
    ReefAngel.Relay.On (VirtCal);
  }
  if (now() - LastUpdate2 >= 300 && LastUpdate2 != 0)
  {
    LastUpdate2 = 0;
    ReefAngel.Relay.Off (VirtCal);
  }
AlkPump and CalPump are the outlets your dosing pumps are on. VirtAlk and VirtCal are outlets on an expansion box that you don't actually have connected (yes, it works!).

I have one expansion relay(Box1) so I use Box2_Port1 and Box2_Port2 for my imaginary relays.

When your real pumps turn on, these imaginary relays turn on and stay on for 5 minutes and will show up on the portal tracking.

HTH,

--Colin

Re: Carbon Vodka Dosing

Posted: Thu Nov 27, 2014 7:50 pm
by Paul_Velasco
Thanks for all the help!
Physically verified that the relays are turning on at 9am, do not show on portal
Will try above code to track

Happy turkey day to everyone

Re: Carbon Vodka Dosing

Posted: Thu Dec 04, 2014 5:36 pm
by Paul_Velasco
Cosmith71 works perfect!! TY

Re: Carbon Vodka Dosing

Posted: Thu Dec 04, 2014 6:40 pm
by cosmith71
Paul_Velasco wrote:Cosmith71 works perfect!! TY
You're welcome!

--Colin