Arduino Water Pressure Sensor?

Post Reply
Piper
Posts: 296
Joined: Fri Jul 20, 2012 7:13 am
Location: Oakley, CA

Arduino Water Pressure Sensor?

Post by Piper »

Has anyone heard of a water pressure sensor that is compatible with Arduino? I'm looking for something that I can put in-line with my R/O system (parts can get wet) that can monitor water pressure up to ~80 PSI or so. I typically run closer to ~60 PSI but would like something that can handle up to ~80 PSI.

~Charlie
rimai
Posts: 12881
Joined: Fri Mar 18, 2011 6:47 pm

Re: Arduino Water Pressure Sensor?

Post by rimai »

I found this:
http://dashboss.myshopify.com/products/ ... -0-100-psi
It's meant for automotive applications. It doesn't say anything about water, but I can't see why not.
Roberto.
Piper
Posts: 296
Joined: Fri Jul 20, 2012 7:13 am
Location: Oakley, CA

Re: Arduino Water Pressure Sensor?

Post by Piper »

Nice! Thanks, Roberto. I found a couple of Digi-Key after posting but the cheapest was over $70. This is a little closer to what I'm willing to spend on this :) I'd need at least two sensors for what I want to do and over $200 for sensors and other hardware would exceed my laziness to cheapskate threshold for this project :)
Piper
Posts: 296
Joined: Fri Jul 20, 2012 7:13 am
Location: Oakley, CA

Re: Arduino Water Pressure Sensor?

Post by Piper »

Post Reply