cloud wifi
Re: cloud wifi
That code looks good.
What is the color of the led on the cloud wifi attachment?
What is the color of the led on the cloud wifi attachment?
Roberto.
Re: cloud wifi
Blink magenta= Connecting to cloud server
That indicates that the username and/or password is most likely wrong.
Make sure you enter the the username and password correctly when setting up the unit. Both fields are case sensitive.
You should get a solid cyan when it is connected to the cloud server.
That indicates that the username and/or password is most likely wrong.
Make sure you enter the the username and password correctly when setting up the unit. Both fields are case sensitive.
You should get a solid cyan when it is connected to the cloud server.
Roberto.
-
- Posts: 15
- Joined: Tue Apr 29, 2014 4:47 am
Re: cloud wifi
is it the user name and password for the reef angel forum
-
- Posts: 15
- Joined: Tue Apr 29, 2014 4:47 am
Re: cloud wifi
done that nothing happens just says connecting and when you refresh says disconnected. just don't think its going to work some how, filled top three lines in on uapp and get data but soon as you go outside nothing.
-
- Posts: 15
- Joined: Tue Apr 29, 2014 4:47 am
Re: cloud wifi
if i fill just cloud server lines in get nothing only connecting
-
- Posts: 15
- Joined: Tue Apr 29, 2014 4:47 am
Re: cloud wifi
is there anyway of re doing it
Re: cloud wifi
Yes.
https://www.dropbox.com/s/zpifv3to1fc5w ... 1.pdf?dl=0
Please check the reset to factory on the manual.
https://www.dropbox.com/s/zpifv3to1fc5w ... 1.pdf?dl=0
Please check the reset to factory on the manual.
Roberto.
-
- Posts: 15
- Joined: Tue Apr 29, 2014 4:47 am
Re: cloud wifi
did the factory re-set went green like it said the led gone off altogether? great.
Re: cloud wifi
Hummm.
Not sure what happened.
Can you connect it to your USB-TTL cable, open Arduino and go to Tools->Serial Monitor.
Make sure you have set at 57600 baud.
Then, open the unit and locate the debug and master button.
Press debug and hold. Then press master and release both.
You should get something on the monitor.
Not sure what happened.
Can you connect it to your USB-TTL cable, open Arduino and go to Tools->Serial Monitor.
Make sure you have set at 57600 baud.
Then, open the unit and locate the debug and master button.
Press debug and hold. Then press master and release both.
You should get something on the monitor.
Roberto.
-
- Posts: 15
- Joined: Tue Apr 29, 2014 4:47 am
Re: cloud wifi
yes got some thing on screen
-
- Posts: 15
- Joined: Tue Apr 29, 2014 4:47 am
Re: cloud wifi
the led is very faint looks red