Trouble Uploading

Basic / Standard Reef Angel hardware
Post Reply
pisanoal1
Posts: 16
Joined: Sun Nov 30, 2014 3:17 pm

Trouble Uploading

Post by pisanoal1 »

So I upgraded tanks, and I went to upload new code to include a dimming module for my lighting. However, I am unable to upload code to my RA. Ive had it for a while and have uploaded code over a dozen times. I did have to buy a new USB to TTL cable because my cat chewed my last one. I get an Error Uploading message, that says connection timed out. I was able to program the Wifi module with this cable. Any ideas?

I should add I got the cable off amazon for shipping speed because I cant run my lights without the dimming module because I bought fans that need to be controlled. It appears to be the same cable.
rimai
Posts: 12881
Joined: Fri Mar 18, 2011 6:47 pm

Re: Trouble Uploading

Post by rimai »

Check if you have the correct board selected on Tools-Boards
Roberto.
pisanoal1
Posts: 16
Joined: Sun Nov 30, 2014 3:17 pm

Re: Trouble Uploading

Post by pisanoal1 »

I checked that. I also reinstalled the cable driver. I ordered another cable from the RA website but I don't have much faith in that
rimai
Posts: 12881
Joined: Fri Mar 18, 2011 6:47 pm

Re: Trouble Uploading

Post by rimai »

Does the controller reboot a few seconds after you hit upload?
Roberto.
pisanoal1
Posts: 16
Joined: Sun Nov 30, 2014 3:17 pm

Re: Trouble Uploading

Post by pisanoal1 »

No it does not
Post Reply