Charts and 0 values
Charts and 0 values
I understand not storing 0's in the DB and all, but when charting values and you get a 0 value, the charts on the portal don't reflect the time between where the 0 values are... So for instance. Moon rise / set, looking at PWMA, it looks like it immediately drops to 0 and then comes back up again, despite there being ~12 hours between the rise and set. Is there anything that can be done so if an interval is 0 the duration of time is shown properly in the chart?
Re: Charts and 0 values
Well, it will show 5 minutes prior and 5 minutes past, right?
Or am I not following?
Or am I not following?
Roberto.
Re: Charts and 0 values
Take the example for rise/set time. In the PWM view yes you will see the 5 minutes prior and past, but you won't "see" the duration to scale with the rest of the data. So what only looks like an instant was 10-12 hours...
Re: Charts and 0 values
Oh, I see what you mean now.
It should show the timeline properly, but it is not doing it.
Need to investigate.
It should show the timeline properly, but it is not doing it.
Need to investigate.
Roberto.