Page 1 of 1

USB connection no longer updating portal

Posted: Mon Sep 26, 2016 5:59 pm
by madweazl
I had to reinstall Windows about a week ago and I havent been able to get the portal to update since. I'm connected via USB. Not sure what I did before that I'm not doing now (migrated from Windows 7 to 10). I have connectivity to the controller and have pushed updated sketches without issue.

Any ideas where to start?

Re: USB connection no longer updating portal

Posted: Mon Sep 26, 2016 6:16 pm
by rimai
Do you use the wifi attachment?

Re: USB connection no longer updating portal

Posted: Tue Sep 27, 2016 2:52 am
by madweazl
No, I dont have the WiFi module (dragging my feet because I need the expansion module too).

Re: USB connection no longer updating portal

Posted: Tue Sep 27, 2016 8:57 am
by rimai
You must have been using the Reef Angel Client then.
You need to install it in your new computer.

Re: USB connection no longer updating portal

Posted: Tue Sep 27, 2016 3:36 pm
by madweazl
rimai wrote:You must have been using the Reef Angel Client then.
You need to install it in your new computer.
I was and I still have it but apparently I've done something differently. The client pulls the labels from portal without issue but doesnt seem to push data.

Edit: "Send parameters to Reef Angel..." box wasnt checked.