That's not correct.
Make sure to connect at 57600 baud rate
When you are connected, type "$$$". It will return with a prompt. type "get e"
Portal Issues
Re: Portal Issues
rimai wrote:That's not correct.
Make sure to connect at 57600 baud rate
When you are connected, type "$$$". It will return with a prompt. type "get e"
Last edited by CalebC on Fri Dec 08, 2017 7:26 am, edited 1 time in total.
Re: Portal Issues
It did not update your host entry.
It should show
So, connect again and send command "set i h 104.36.18.155"
Then send "save" and send "reboot"
Just to make sure it updated, grab the "get e" again and see if it updated.
If it did, you are all good.
It should show
Code: Select all
HOST=104.36.18.155
Then send "save" and send "reboot"
Just to make sure it updated, grab the "get e" again and see if it updated.
If it did, you are all good.
Roberto.