Page 1 of 1

Re: Portal Issues

Posted: Wed Dec 06, 2017 11:40 pm
by rimai
That's not correct.
Make sure to connect at 57600 baud rate
When you are connected, type "$$$". It will return with a prompt. type "get e"

Re: Portal Issues

Posted: Thu Dec 07, 2017 2:44 pm
by CalebC
rimai wrote:That's not correct.
Make sure to connect at 57600 baud rate
When you are connected, type "$$$". It will return with a prompt. type "get e"

Re: Portal Issues

Posted: Thu Dec 07, 2017 4:07 pm
by rimai
It did not update your host entry.
It should show

Code: Select all

HOST=104.36.18.155
So, connect again and send command "set i h 104.36.18.155"
Then send "save" and send "reboot"
Just to make sure it updated, grab the "get e" again and see if it updated.
If it did, you are all good.