my water level expansion has been unplugged for a while because I didn't have a good way to attach the pipe in my water reservoir. I plugged it in to my expansion hub yesterday and my salinity probe reading dropped from its normal 35 ppt down to 6 ppt. I unplugged the water level expansion and the salinity went back up to 35 ppt. I tried a couple more times of plugging and unplugging with the same results. I believe I tried different expansion ports but I don't recall now for sure.
I'm not sure what else to try with it. Any ideas or suggestions?
Sent from my XT1585 using Tapatalk
water level expansion problems
Re: water level expansion problems
It may be bad
Do you get reading when connected straight into the relay box?
Do you get reading when connected straight into the relay box?
Roberto.
Re: water level expansion problems
I was afraid it was bad.rimai wrote:It may be bad
Do you get reading when connected straight into the relay box?
I haven't tried it plugged straight in to the controller. I didn't even think to try that. I will test that tomorrow and see what it does.
Sent from my XT1585 using Tapatalk
Re: water level expansion problems
So I tested it today and still nothing with the water level expansion device. I plugged it directly into my relay box and it still isn't reading anything. Any further checks I need to do?
Re: water level expansion problems
Are you getting any bus locks?
Did you try a different USB cable?
Did you try a different USB cable?
Roberto.
Re: water level expansion problems
no bus locks that im aware of. I will try a different, known working cable.
i will test more today when I update the code on the controller and change my light fixtures.
Sent from my XT1585 using Tapatalk
i will test more today when I update the code on the controller and change my light fixtures.
Sent from my XT1585 using Tapatalk
Re: water level expansion problems
well, it appears to be working fine now. I tested a different cable and it worked. then I switched back to the original cable and that works just fine.
I think my problem was a combination of a faulty connection to the expansion hub and the usb contacts needed cleaned up a bit.
regardless, everything is working properly now. thanks!
Sent from my XT1585 using Tapatalk
I think my problem was a combination of a faulty connection to the expansion hub and the usb contacts needed cleaned up a bit.
regardless, everything is working properly now. thanks!
Sent from my XT1585 using Tapatalk