Page 1 of 1

Using Ethernet to Make Sketch Smaller?

PostPosted: Wed Sep 26, 2018 6:12 pm
by n1ng
Hi,

I'm wondering if anyone using ethernet to connect to the portal would know if my sketch would be smaller vs using wifi.

I have a first gen board and my understanding is the <RA_Wifi.h> portion of the sketch is quite large. Could I omit it if I use ethernet?

Thanks!

Re: Using Ethernet to Make Sketch Smaller?

PostPosted: Wed Sep 26, 2018 9:28 pm
by rimai
No, it will not do you any good.
You need the wifi library to use the ethernet too.

Re: Using Ethernet to Make Sketch Smaller?

PostPosted: Thu Sep 27, 2018 6:04 am
by n1ng
Thanks!