Taking the Jebao WP pumps to 0 on reboot?
Posted: Tue Aug 06, 2013 7:33 am
Roberto or others.
I was reading the LDD driver discussion on RC and noticed that at some point in time they added a 10K ohm 1/2W resistor to pull the PWM signal to 0 when there was no power to the driver or during a reboot of the controller.
Is this something that is possible to keep the Jebao pumps from running at full power when the Reef Angel reboots?
I was reading the LDD driver discussion on RC and noticed that at some point in time they added a 10K ohm 1/2W resistor to pull the PWM signal to 0 when there was no power to the driver or during a reboot of the controller.
Is this something that is possible to keep the Jebao pumps from running at full power when the Reef Angel reboots?