Hi Roberto,
I just updated to the DevLib 1.0 and tried the wizard.... very nice. Question though, I setup the aquarium heater with the on and off temps. Which temp probe is used?
Temp probe ports
Re: Temp probe ports
T1 by default, but you can change it.
This line is what defines the probe:
This line is what defines the probe:
Code: Select all
ReefAngel.TempProbe = T1_PROBE;
Roberto.
-
- Posts: 84
- Joined: Sun Mar 11, 2012 10:38 am
Re: Temp probe ports
I am getting an error on all temp ports regardless of which one I plug a probe into, any ideas?
Re: Temp probe ports
Try one at a time, but you need to reboot the controller everytime you plug a probe to make sure it is picked up by the controller.
Roberto.
-
- Posts: 84
- Joined: Sun Mar 11, 2012 10:38 am
Re: Temp probe ports
Just figured that out, thank you. I see that the code lists a Temp probe and a separate overheat probe that is also defaulted to T1. Could I change the overheat probe to T2 and use the second probe to monitor the temp of my lights and bring on a fan to cool them down?
Re: Temp probe ports
Yeah
You can pick whichever probe you want for temp probe and for overheat probe
You can pick whichever probe you want for temp probe and for overheat probe
Roberto.