Wifi attachment commands
Re: Wifi attachment commands
Thanks!!
What you are getting is the intended result. It was a mistake on that post. I corrected it.
It has to be something within your code.
It is not the override as you can see it in here: http://forum.reefangel.com/status/chart ... filter=rfb
Can you open a new thread?
What you are getting is the intended result. It was a mistake on that post. I corrected it.
It has to be something within your code.
It is not the override as you can see it in here: http://forum.reefangel.com/status/chart ... filter=rfb
Can you open a new thread?
Roberto.
Re: Wifi attachment commands
I'll start a new thread... just the typo was noticed when I tried to see if the override would help reset it.
Re: Wifi attachment commands
what is the usage of the /cal command? can it be used to trigger the calibration modes?
Re: Wifi attachment commands
awesome. thanksrimai wrote:Yes, I updated the OP
Re: Wifi attachment commands
There is no way to read/write a dword (i.e. InternalMemory.read_dword() / InternalMemory.write_dword() )
Need to ad a /md
Need to ad a /md
Re: Wifi attachment commands
Can you add a ticket on github?
Sent from my SPH-L710 using Tapatalk
Sent from my SPH-L710 using Tapatalk
Roberto.
Re: Wifi attachment commands
Yeah, I'll add this and need to add HighATOChannel to DCPump
Re: Wifi attachment commands
I have the same question, is there a schema for the data that /sr or /sa will return? The answer to genuflect is begged!!
Re: Wifi attachment commands
If you want to know what the schema looks like, then you need to view the code. It's located in the RA_Wifi/RA_Wifi.cpp file. Here's a link to the github location of the file:Hamid2 wrote:I have the same question, is there a schema for the data that /sr or /sa will return? The answer to genuflect is begged!!
https://github.com/reefangel/Libraries/ ... A_Wifi.cpp
Around line 300, there will be a line that says "case REQ_R_STATUS:"
That section shows the the XML code that is generated by those 2 commands.
Re: Wifi attachment commands
Any way to add a command to clear a bus lock flag? If it's possible I'll open an issue.
Re: Wifi attachment commands
I could be missing something obvious.. but when I call the waterchange mode from the wifi... how do I take the RA out of WC mode? Do I make the same call again to toggle it?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Wifi attachment commands
Of course looking at this now - it makes perfect sense. I'm going to blame being tired.
Do you know if there's a way to check if WC or Feed mode are already active?
Do you know if there's a way to check if WC or Feed mode are already active?
Re: Wifi attachment commands
Yes. The SF flag is an 8 bit representation of different modes.
At the moment, we only use the first 3 bits.
At the moment, we only use the first 3 bits.
Code: Select all
// Status Flag Bits
#define LightsOnFlag 0
#define FeedingFlag 1
#define WaterChangeFlag 2
Roberto.