Updated to 1.1.0, Screen dead
Updated to 1.1.0, Screen dead
I updated to the new libraries today and now my screen is random colors and lines. I removed my custom screen and graph code and the problem is still there. The attached code is the stripped down version, my portal and app still work normally only the controller screen is not operating normally. I attempted updating the code multiple times with the same result, it is a non plus ra, with a gen 1 screen and wifi.
- Attachments
-
- sketch_nov3_2013_v1.ino
- (2.19 KiB) Downloaded 517 times
Re: Updated to 1.1.0, Screen dead
Try adding this to your setup() section:
Code: Select all
InternalMemory.LCDID_write(0);
Roberto.
Re: Updated to 1.1.0, Screen dead
It did change things, now the screen is just all black but backlit. I attached the code to make sure I placed the command in the correct place. Thanks for your help.
- Attachments
-
- sketch_nov3_2013_v1.ino
- (2.23 KiB) Downloaded 505 times
Re: Updated to 1.1.0, Screen dead
My bad...
Misread the 1st post.
Gen 1 needs to be like this:
It's placed correctly.
Misread the 1st post.
Gen 1 needs to be like this:
Code: Select all
InternalMemory.LCDID_write(255);
Roberto.
Re: Updated to 1.1.0, Screen dead
Well now its back to the random colors and lines again. I attached my code with the custom menu and graph. I tried loading this code (with the line you suggested) to see if that made any difference. Unfortunately, no.
- Attachments
-
- sketch_nov3_2013_v1.ino
- (2.8 KiB) Downloaded 494 times
Re: Updated to 1.1.0, Screen dead
I think it is unrelated to the lib update.
Your screen may just be bad.
Can you check if it is properly seated?
Your screen may just be bad.
Can you check if it is properly seated?
Roberto.
Re: Updated to 1.1.0, Screen dead
I reseated the screen with no changes, it is just weird that it worked perfectly until I updated the library and then controller.
Re: Updated to 1.1.0, Screen dead
When I load examplecode1 I go back to a black screen.