I installed and it works well.
Very easy to configure.
Congratulations for your good work.
I find a little issue, in app my Orp value is 47.7mv but in reality it's 477mv.
this is not a major problem.

Thank you very much for this app.
Wow
I installed and it works well. Very easy to configure. Congratulations for your good work. I find a little issue, in app my Orp value is 47.7mv but in reality it's 477mv. this is not a major problem. ![]() Thank you very much for this app. Osaka 40g with 55g sump Radion, 2X Tunze 6045, Swc-160 mini cone |
|
I will look at the formatting. i thought it was that way from my Android app. thanks for pointing that out.
Sent from my Nexus 7 |
|
Thanks for all the work Curt. Just want to make sure I'm not missing something here - v1.0 is sensor status only, no outlet status or control, feed mode, etc.?
|
|
Correct. I'm already working on the other stuff. I think I mentioned in an earlier post that I have the relay status control working but not the modes. |
|
Wow Congrats!!! Thanks you. Finally I can view my water parameters using my IOS 7.
Can't wait to check out the updated versions your working on. For more functions work. ![]() |
|
I do have a question to ask.....would people like to have this app built to run on iOS 6.1 or 6.0 as well?? Or is leaving it at iOS 7 and later ok? I think I should be able to make it run on iOS 6.1 or 6.0 pretty easily (just compile against that version).
![]() |
|
You may not use any features yet that need ios7 but why limit yourself. But if its just a matter of compiling...then why limit it. I think for the most part if someones on the old version of ios then they have the previous version to use as well...
|
|
Outstanding! Thank you Curt
|
|
Agreed. I believe it's just as simple as compiling against ios6 but I have to confirm. I will have to do some testing to find out for certain. |
|
-Dave
|
|
Users browsing this forum: No registered users and 1 guest