Wavemaker Help

Requests for new functions or software apps
Post Reply
Spotted
Posts: 101
Joined: Thu May 10, 2012 5:46 am
Location: Sunny (and hot) South Florida

Re: Wavemaker Help

Post by Spotted »

Awesome work, everything is working perfectly!!
Now on to another problem. I think I may have a bad PH probe. I tried to calibrate it like we discussed earlier, with the original RA code and I am not getting correct readings, I think.
First I rinsed in RO, then into 7.0 which read 469. Then rinsed again and into the 10 which read 474. I didn't think these numbers were any good, but I put the probe back in my sump and it jumped between 7 and 10. Nothing in between , just 7 or 10.
I then repeated the calibration and nothing really changed. Now it's in my sump and is reading 14!!

Any suggestions?
Image
rimai
Posts: 12881
Joined: Fri Mar 18, 2011 6:47 pm

Re: Wavemaker Help

Post by rimai »

Cool. PM for an RMA number.
Roberto.
Spotted
Posts: 101
Joined: Thu May 10, 2012 5:46 am
Location: Sunny (and hot) South Florida

Re: Wavemaker Help

Post by Spotted »

So, as of this morning, I got a message on the screen says

No Internal Memory Found

Only the return pump was running. I tried reflashing and it looks like it uploads, lights on the unit blink and flash just like it was uploading and the programmer runs through the normal flash routine, but same message on the screen.
I tried power cycling and now nothing is running and I tried reflashing and same thing.

What to do now?
Image
rimai
Posts: 12881
Joined: Fri Mar 18, 2011 6:47 pm

Re: Wavemaker Help

Post by rimai »

Upload InitialInternalMemory code
File->Sketchbook->Example Codes->InitialInternalMemory
Roberto.
Spotted
Posts: 101
Joined: Thu May 10, 2012 5:46 am
Location: Sunny (and hot) South Florida

Re: Wavemaker Help

Post by Spotted »

Thanks, I'll give it a shot when I get home. Any idea why that happened?
Image
Spotted
Posts: 101
Joined: Thu May 10, 2012 5:46 am
Location: Sunny (and hot) South Florida

Re: Wavemaker Help

Post by Spotted »

Ok, got it back up and running. Any idea what might have happened, so I don't do it again?
Image
rimai
Posts: 12881
Joined: Fri Mar 18, 2011 6:47 pm

Re: Wavemaker Help

Post by rimai »

Humm.. not sure...
Did you upload anything or changed internal memory ?
Roberto.
Spotted
Posts: 101
Joined: Thu May 10, 2012 5:46 am
Location: Sunny (and hot) South Florida

Re: Wavemaker Help

Post by Spotted »

I restored the original code to calibrate the PH probe, but then reloaded my code. I then got caught up in the election and left the usb connected, but I had shut the PC down.
Came back in the AM and it was not working. To be honest, I'm not certain it was working right last night. It was after 10 when everything shuts off..
Anyhow, it's all working again, thanks!!
Image
Post Reply