Page 1 of 1

Z-wave intergration

Posted: Wed Nov 19, 2014 3:51 pm
by westonhull
Hello,
I was wondering if there was any thoughts of being able to talk to any zwave controller (vera, Smart things, GE, etc)? Most controllers are able to communicate with RS232, usb, wifi, rf, x10, etc. With this option you would might be able to integrate the automation and wireless side.

Thanks,
Wes

Re: Z-wave intergration

Posted: Sun Nov 30, 2014 10:53 pm
by westonhull
Guess no one thinks this could be beneficial.

Re: Z-wave intergration

Posted: Mon Dec 01, 2014 9:51 am
by rimai
You can connect through RS232, but that would use the port that you use for the wifi attachment.
Doe the zwave controller also communicate through xbee?

Re: Z-wave intergration

Posted: Wed Dec 03, 2014 5:53 pm
by westonhull
Not this controller. I wish it did. So is there a way to make like a Y adapter

Re: Z-wave intergration

Posted: Wed Dec 03, 2014 6:30 pm
by rimai
Not without a traffic control signal to indicate where to send the signal to.