ATO Pump - How do I program?
-
rossbryant1956
- Posts: 471
- Joined: Sat Jan 14, 2012 2:08 pm
- Location: Montgomery Village, MD
ATO Pump - How do I program?
I will soon be doing a complete install for a colleague and was very intrigued to see some of the new products now available from RA. I am particularly interested in the ATO pump and using my two standard float valves to control it. Primarily wanted to make sure I can program the ATO High and Low to turn that pump on and off. I read the thread about not too much head but wanted to be sure. Please advise. Thx
Roscoe's Reefs - Starting Over Again:
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
-
rimai
- Posts: 12857
- Joined: Fri Mar 18, 2011 6:47 pm
Re: ATO Pump - How do I program?
Steve is using it with 9 foot head.
You can turn on and off just like any other pump, by just using one relay port.
You can turn on and off just like any other pump, by just using one relay port.
Roberto.