Remote PWM

Related to the Portal
Post Reply
ufgators2k
Posts: 58
Joined: Sun May 12, 2013 2:21 pm

Remote PWM

Post by ufgators2k »

Is there a way to remotely set the current PWM channel levels?
Image
User avatar
Sacohen
Posts: 1833
Joined: Sun Apr 21, 2013 6:25 am
Location: Davie, FL

Re: Remote PWM

Post by Sacohen »

Are you talking about the current for Jebao Pumps like the WP-25 or 40?

The answer is yes. You would need to set you code for the pumps to use the internal memory and then you can adjust setting in the web portal under Internal Memory>DC Pump (Jebao/Tunze)
ufgators2k
Posts: 58
Joined: Sun May 12, 2013 2:21 pm

Re: Remote PWM

Post by ufgators2k »

Sorry I should have been more clear. I had spotty Internet where I was. I have four Rapid LED drivers controlled via PWM. I want to be able to turn down the level remotely. The currently run on the parabola setting.
Image
User avatar
Sacohen
Posts: 1833
Joined: Sun Apr 21, 2013 6:25 am
Location: Davie, FL

Re: Remote PWM

Post by Sacohen »

I'm not 100% sure of that, but I think you can. I'm sure someone else with more knowledge on this will chime in.
rimai
Posts: 12881
Joined: Fri Mar 18, 2011 6:47 pm

Re: Remote PWM

Post by rimai »

Yes, you can do that.
If you choose the path of using internal memory when using the wizard, you can use the portal to change the % of each channel for both start and end whenever you want to :)
Roberto.
ufgators2k
Posts: 58
Joined: Sun May 12, 2013 2:21 pm

Re: Remote PWM

Post by ufgators2k »

Is there any functional difference between using the memory vs calling the function in code?
Image
Post Reply