Controll X-10

ewaldsreef · Post by **ewaldsreef** » Sun May 10, 2015 9:15 am

I might get a hard time for this but oh well. I still run X-10s in my home for a few things. There are a few outlets I would like to control via my RA based on comands to my lights.
How difficult would it be to add an X-10 line interface to the RA?

lnevo · Post by **lnevo** » Sat May 23, 2015 8:22 pm

It might be easier to get an x-10 relay sensor and trigger an x-10 event from that using the io module. If you have an x-10 controller or are running x-10 computer software then you could trigger macros from that

ewaldsreef · Post by **ewaldsreef** » Wed May 27, 2015 3:28 pm

I am getting into a new project "openhab" to seperate my home automation stuff. Actually what you are saying with the I/O makes sense and is a good idea.

lnevo · Post by **lnevo** » Fri May 29, 2015 3:51 pm

I went through a lot of x-10 playing before I finally decided on the reef angel...the kicker was x-10 wouldnt operate through a UPS...best decision anyway

ewaldsreef · Post by **ewaldsreef** » Sat May 30, 2015 8:53 pm

I agree . The X10s are just for some other non aquarium things.

AlanM · Post by **AlanM** » Fri Jun 12, 2015 10:43 am

Roberto is adding Zigbee, I believe, as a possibility for control in the future. I know plenty of home automation also uses Zigbee, so maybe in the near future there will be a convergence of being able to control stuff in the house and aquarium.

rimai · Post by **rimai** » Fri Jun 12, 2015 6:24 pm

The RANet modules run on the XBee modules.

Reef Angel Forum

Controll X-10

Controll X-10

Re: Controll X-10

Re: Controll X-10

Re: Controll X-10

Re: Controll X-10

Re: Controll X-10

Re: Controll X-10

Login • Register