USB to Controller power cord

joshlawless · Post by **joshlawless** » Sat May 16, 2015 2:15 pm

The USB to 3-pin temperature probe header cord that came with my unit is sure a tight fit on the header pins. So tight, that when I went to pull it out, the wires came out of the 3-pin connector. I'd like to reseat them, but want to be sure the right wire goes in the right hole -- what's the correct wire order, from pin 1 to pin 3?

cosmith71 · Post by **cosmith71** » Sun May 17, 2015 6:01 am

Here you go. The two black bars are the raised areas on the plug. Don't trust wire colors. Check the signal with a voltmeter if you can. This is a temp probe, but it's the same. You need to connect to the two outer pins.

Reef Angel Temp Probe Connector.jpg

--Colin

joshlawless · Post by **joshlawless** » Mon May 18, 2015 2:59 pm

Thanks!

Reef Angel Forum