ok, set up and everything is running ok, but

Do you have a question on how to do something.
Ask in here.
Post Reply
miked
Posts: 86
Joined: Fri Feb 10, 2012 11:06 am

ok, set up and everything is running ok, but

Post by miked »

my led fan should be set to auto and be turned on when the LED light power port turns on also. I thought I had them both set to 'standard lights' and set the standard light on/off at a specified time but the fan port is not on during auto. is there a way to check and modify these settings after the code has been set up and is running? also need to check my heater settings.

thanks
Image
rimai
Posts: 12857
Joined: Fri Mar 18, 2011 6:47 pm

Re: ok, set up and everything is running ok, but

Post by rimai »

You can see the memory settings with smart phone app or Client software.
Roberto.
miked
Posts: 86
Joined: Fri Feb 10, 2012 11:06 am

Re: ok, set up and everything is running ok, but

Post by miked »

rimai wrote:You can see the memory settings with smart phone app or Client software.
I guess what I am asking is to see the Code that is currently on my RA. Is that possible? I want to check my PWM and ATO specifically to make sure they are correct as I am not seeing the Code work as I thought I entered it. Probably just did not enter it how i intended but would like to verify.

thanks
Image
binder
Posts: 2865
Joined: Fri Mar 18, 2011 6:20 pm
Location: Illinois
Contact:

Re: ok, set up and everything is running ok, but

Post by binder »

No you are unable to see the code that is currently installed on the controller. That's just not possible.
miked
Posts: 86
Joined: Fri Feb 10, 2012 11:06 am

Re: ok, set up and everything is running ok, but

Post by miked »

binder wrote:No you are unable to see the code that is currently installed on the controller. That's just not possible.
thanks, I think I just uploaded the internal memory differently than planned but the PWM slope worked nicely for me yesterday and everything else is fine now that I updated temperature requirements and light on/of settings from the client.

thanks for all your help guys this has been the best investment in my first reef setup.
Image
rossbryant1956
Posts: 471
Joined: Sat Jan 14, 2012 2:08 pm
Location: Montgomery Village, MD

Re: ok, set up and everything is running ok, but

Post by rossbryant1956 »

and the most fun...and the most frustrating...and...and

Thx to all for their help.
Roscoe's Reefs - Starting Over Again:

Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
Post Reply