Not looking for anything fancy right now...just want a sunrise/sunset effect...
Code: Select all
// Autogenerated file by RAGen (v1.2.2.171), (05/22/2012 14:47)
// RA_052212_1447.ino
//
// This version designed for v0.9.0 or later
//The following features are enabled for this File:
#define DisplayImages
#define DateTimeSetup
#define VersionMenu
#define DirectTempSensor
#define DisplayLEDPWM
#define SIMPLE_MENU
#define PWMEXPANSION
#define RFEXPANSION
#define IOEXPANSION
#include <ReefAngel_Features.h>
#include <Globals.h>
#include <RA_Wifi.h>
#include <Wire.h>
#include <OneWire.h>
#include <Time.h>
#include <DS1307RTC.h>
#include <InternalEEPROM.h>
#include <RA_NokiaLCD.h>
#include <RA_ATO.h>
#include <RA_Joystick.h>
#include <LED.h>
#include <RA_TempSensor.h>
#include <Relay.h>
#include <RA_PWM.h>
#include <Timer.h>
#include <Memory.h>
#include <RF.h>
#include <IO.h>
#include <ReefAngel.h>
////// Place global variable code below here
// LEDPWM Channel defines for easy code reading
#define LEDPWM0 0
#define LEDPWM1 1
#define LEDPWM2 2
#define LEDPWM3 3
// Initial values to all 6 channels at startup. They will always be 0.
byte PWMChannel[]={
0,0,0,0,0,0};
////// Place global variable code above here
void setup()
{
// This must be the first line
ReefAngel.Init(); //Initialize controller
// Ports that are always on
ReefAngel.Relay.On(Port2);
ReefAngel.Relay.On(Port5);
ReefAngel.Relay.On(Port6);
ReefAngel.Relay.On(Port7);
ReefAngel.Relay.On(Port8);
////// Place additional initialization code below here
////// Place additional initialization code above here
}
void loop()
{
////// Place your custom code below here
//Start of PWM Expansion Code for Slope
PWMChannel[LEDPWM0]=PWMSlope(11,00,17,00,20,80,60,PWMChannel[LEDPWM0]);
PWMChannel[LEDPWM1]=PWMSlope(10,00,18,00,20,80,60,PWMChannel[LEDPWM1]);
PWMChannel[LEDPWM2]=PWMSlope(9,30,18,30,20,80,30,PWMChannel[LEDPWM2]);
PWMChannel[LEDPWM3]=PWMSlope(10,30,17,30,20,80,30,PWMChannel[LEDPWM3]);
// The lines above are what calculates the slope.
// You can change the schedule by changing the parameter inside the parenthesis of the PWMSlope() function
// The are as follow:
// 1st parameter: hour to start slope
// 2nd parameter: minute to start slope
// 3rd parameter: hour to end slope
// 4th parameter: minute to end slope
// 5th parameter: % of the PWM signal to start slope
// 6th parameter: % of the PWM signal to end slope
// 7th parameter: duration of slope in minutes
// 8th parameter: always the same as the variable before the PWMSlope() call
////// Place your custom code above here
// This should always be the last line
ReefAngel.ShowInterface();
}
