Reef Angel Forum

Ok so every time I set the AirPort Extreme to open port 2000 on a specific IP address the wifi controller jumps to a different ip. 5 hours and its still killing me. I give up for the night. All other functions seem to be fine and direct connect works.

Thanks. I'll try it today.

Not working followed the instructions to the letter, it still changes the address of the wifi adapter as soon as I set the port mapping.

ok not sure how I got it but I did. Now my question is how do I know that the program is running and not on some sort of override from pushing buttons on the iPad?

On the ipad if you see blue dots next to your relays they are overrides. Click them and the relays will go back to their "normally scheduled program"

Thanks, my code must be off because when I hit the blue dot's for ports that should be on (main pump) it shuts off.

Sounds like it..

Does the ra need to be plugged into the computer to use the wizard or is there a way to use wifi?

Computer has to be plugged in to the RA to upload code

Thank you