Page 1 of 1
pwm connector
Posted: Thu Apr 18, 2013 7:41 pm
by duck
pwm 2 pin connector? where can i get this local or is it only available on the site?
Re: pwm connector
Posted: Thu Apr 18, 2013 9:34 pm
by rimai
Yes, dimming port lead wire on the webstore
Re: pwm connector
Posted: Wed May 15, 2013 7:21 am
by ufgators2k
The dimming port lead wire on the webstore is a two pack (one for actinic, one for daylight)? It is hard to see in the picture but I assume the other end is bare wire that can be paralleled together for multiple drivers.
Re: pwm connector
Posted: Wed May 15, 2013 7:29 am
by rimai
Correct for both.
Re: pwm connector
Posted: Tue May 21, 2013 10:35 am
by chapboogie
Is there a thread, or tutorial on how to wire in led drivers?
Re: pwm connector
Posted: Wed May 22, 2013 5:27 am
by cosmith71
chapboogie wrote:Is there a thread, or tutorial on how to wire in led drivers?
It's easy. + on the RA to + dimmer, - on the RA to - on the dimmer. The markings on the RA wire may be reversed, so go by the actual pins instead. The pin-out is in the RA manual.
--Colin
Re: pwm connector
Posted: Mon Jun 10, 2013 1:49 pm
by ufgators2k
I didn't see it in the manual, did I miss it?
Re: pwm connector
Posted: Mon Jun 10, 2013 2:08 pm
by cosmith71
7th page. It's a big picture on the page by itself.
--Colin
Re: pwm connector
Posted: Mon Jun 10, 2013 6:23 pm
by ufgators2k
Thanks. I know why I missed it. The screen I was on was too small to see the pins without zooming in.