Page 1 of 1

Need help with MacBook....

Posted: Mon Jun 03, 2013 6:52 pm
by rweber504
Hello....Can anyone for the life of me can tell me why my MacBook 10.6.8 does not work with my ReefAngel controller?
Everytime I try to upload a simple file it says "error=86, Bad CPU type in executable
at java.lang.ProcessBuilder.start
at java.lang.Runtime exec(Runtime.java.593)
at java.lang.Runtime exec(Runtime.java.466)"

I was lucky enough to get it to work with my RA wi-fi module when it had to be reprogrammed. Other than that ,no luck.
I've had friends come over with their PC computers to program my RA controller with no problem. Please, any ideas are welcome! I'm Begging!!!

Randy :?:

Re: Need help with MacBook....

Posted: Mon Jun 03, 2013 8:02 pm
by dbmet
What processor do you have in your mac? Have you tried this thread?
http://forum.reefangel.com/viewtopic.php?t=2987

Re: Need help with MacBook....

Posted: Fri Jun 07, 2013 1:31 am
by rweber504
Thanks I'll check it out...cause I'm really trying to like this controller! I also have an issue where my WiFi lite is flashing green but my Iphone RA app is not responding. What gives?

Re: Need help with MacBook....

Posted: Fri Jun 07, 2013 8:05 am
by rimai
Are you using the correct IP address in the iphone app? Do you also have direct mode turned on?

Re: Need help with MacBook....

Posted: Fri Jun 07, 2013 9:01 am
by DrewPalmer04
rweber504 wrote:Thanks I'll check it out...cause I'm really trying to like this controller! I also have an issue where my WiFi lite is flashing green but my Iphone RA app is not responding. What gives?
Learning curve. It'll pay off. Trust me :)

Re: Need help with MacBook....

Posted: Fri Jun 07, 2013 4:17 pm
by dbmet
What IP address are you using on your iPhone? Did you check to make sure port 2000 is forwarded to your reef angel

Re: Need help with MacBook....

Posted: Fri Jun 07, 2013 4:31 pm
by rweber504
Yeah, port forward is 2000, IP is correct...I changed Internet services from Cox to optic fiber LUS services. Maybe I need to check my router settings?