Newbie Hardware Question (PWM Dimming)

TheMikey · Post by **TheMikey** » Fri Oct 11, 2013 8:15 am

I've just finished wiring my DIY LEDs and want to test the strings. However, I am at a loss of how to connect the dimming wires from my Meanwell Drivers to the Relay Box. I've tried searching but I've thus far been unsuccessful. Is there a type of particular plug that fits so I can just splice the wires from my project box?

Any help is greatly appreciated.

rimai · Post by **rimai** » Fri Oct 11, 2013 9:14 am

You can buy the dimming port lead wire in the webstore.
You can also make your own if you have the parts.

TheMikey · Post by **TheMikey** » Fri Oct 11, 2013 10:28 am

Oh wow! I scanned the store for almost an hour yesterday and didn't stumble across it. Found it in five minutes today... Thanks Roberto!

Reef Angel Forum