Luxdrive A011-D-V-700 driver
Posted: Sun Jan 08, 2012 12:22 pm
Anybody have experience with this driver and the RA? The datasheet states its compatible with either PWM or normal 0-10v analog signal.
Datasheet can be found here
http://luxdrive.com/content/FlexBlock_A011_V1.pdf
I used these on a prototype build with some epistar LED's and I was fairly impressed. They were putting out from 710-720mA for each string of 12. I tried them on a pot and everything worked well, but when I get my RA after they are back in stock, I will be doing an extreme DIY build.
Anybody chime in with their experiences, or am I the only one that tried them out?
TIA
Datasheet can be found here
http://luxdrive.com/content/FlexBlock_A011_V1.pdf
I used these on a prototype build with some epistar LED's and I was fairly impressed. They were putting out from 710-720mA for each string of 12. I tried them on a pot and everything worked well, but when I get my RA after they are back in stock, I will be doing an extreme DIY build.
Anybody chime in with their experiences, or am I the only one that tried them out?
TIA