Reef Angel Forum

Just wondering if anyone has any idea why the internal memory wasn't working? It made it really easy to tweak the lights so ideally I'd switch it back to internal mem.
Thanks!

Yes, I replaced the PWM lines with the following: ReefAngel.PWM.SetChannel( 0,PWMSlope( 12,30,23,30,11,20,45,0 ) ); ReefAngel.PWM.SetChannel( 1,PWMSlope( 12,0,23,55,11,66,30,0 ) ); ReefAngel.PWM.SetChannel( 2,PWMSlope( 12,0,23,59,11,25,60,0 ) ); I uploaded the code, the lights came on and I see numb...

I tried going into the internal memory settings in the portal, changing the values in the dimming expansion section and saving, just to see if that'd maybe get something to update. No luck there, still 0s showing up on the RA+ Dimming channels. Here's what showed up on the portal after saving: Savin...

Still no luck. I deleted all lines with DCPump, even the include line, uploaded the code, all channels still show 0. The DC Pump menu no longer shows on the RA+ display, which I guess is expected now.

No, the RA actually shows 0% on the screen for all the dimming channels as well as for the DC Pump speed. I tried commenting all the lines starting with ReefAngel.DCPump. and re-uploaded the code. Still seeing 0s across the board on the RA+ screen. I'm sure its possible that in the years since I've ...

Thanks binder, I just tried that but no luck. I used a new USB cable as well as a couple different port on the expansion module but my lights are still off. Any idea why the dashboard would show all the channels at 0%? Is there any way for me to test the dimmer module?
Thanks!

I've traditionally used the arduino software to upload code to my RA+ and it's been years since I've touched the code. Recently my multi-water level sensor crapped out so I had to get a new one and re-calibrate it which meant uploading new code to to my RA with updated water levels. I copy-pasted my...

I'd like to comment on this. I recently had a water level sensor go nuts on me and had to get it replaced. The disturbing part was that even though the ATO Timeout was triggered, if the water level (or in my case a bad water level reading) exceeded the High%, as soon as the water level dropped back ...

Just tried to install this on the mac and the installer failed. Not a very descriptive error either

I created a mount for the head unit by shaping a piece of acrylic to hold the unit by its sides. I used thin enough acrylic so that it remains flexible, which allows me to pop the head unit in and out of the mount. I measured how long the sides and back of the unit was, marked where i wanted my bend...

uhoh, I hope its not due to github issue 138? how far away is this feature from being implemented?

Hey all, I've got a RA+ with the Mult-Channel Water level expansion. I'm trying to switch everything over to internal memory but running into a problem where it seems that, by default, the RA Wizard assumes that channel 0 is the one to watch for the water level. The problem is that it should be look...

This little nugget of info would be great in the manual. Something about adjusting the length of pipe to the length you're ultimately going to use for installation, before calibration, and then calibrating in a flower pot/vase/whatever/ is cool as long as you get it up to the sensor so that the sens...

Tried that. It turns the screen blank. The same result I get when I leave them both blank. Just thought I'd throw this out there because I hit the same issue. When using the wifi_utility, it seems to expect something in the passphrase field, even if you are using an open network without encryption....