Reef Angel Forum

Thank You for the info.
I will check for stray voltages.

Last week I reload a new sketch after adding ATO with one float switch using relay 6. After that PH drop to 7.0. I try recalibrate with PH 7 and PH 10 fluid a few time. PH still reading 7.0 My PH pen read 8.0 . I remove the probe from the tank and fill a cup with tank water . Put the probe into the ...

I manage to upload the sketch after changing the board.Thank Yo rimai

I do not know what happen.
Today I try to upload a sketch I create using the Reef Angel Wizard under Tools
Everytime I upload I get the error message: Error uploading

I try many times. Rewrite the sketch using the Reef Angel Wizard and reupload.
Still the same.

Please help

Thank You for the pointing out and also give a solution.(Inevo and rimai) Yes we will not turn on the return pump automatically. We will disable the return pump and check and clear the problem. So does your script send out an sms or email to the mobile? And how the pump can be turn on again after th...

Thank You for your highlight.
This is to prevent the return pump from running dry when the down flow pipe is partially choke and upflow and download cannot balance.

I am a new owner of Reef Angel Controller. I do not know any thing about programming. I want to use one of the float switch to control my return pump in port 1. When the float switch sense water level low the return pump should stop and the return pump will resume when the water level is correct aga...