Reef Angel Forum

Any point in running the wifi setup again if I can already communicate locally through the wireless router?

Hughes Gen4 modems do not support port forwarding it seems. I got this from a link their support forum. "Cody Jackson October 27, 2013 at 5:30 pm | Permalink As you’ve noticed, there’s no port forwarding with the HT1000 because the addresses it gives out aren’t public addresses. If you really n...

OK thanks. I'll look into the port forwarding further. It's my satellite modem that does not have a static IP. Not sure if I was clear about that. I went to what's my IP and got my external IP then entered that into my profile in the UCP on this site. However, my external IP changes, (probably when ...

In that case...Anyone want to buy a used Reef Angel controller?

I recently upgraded my Hughes Net satellite modem and ever since I can't connect to my RA using the portal. Prior to the upgrade I only had read access to the RA but that was sufficient for remote monitoring and alarming. I can connect to the RA locally via my wireless router just not over the inter...

I got the new pump head on Saturday and it works great! Thanks Roberto. Now I'd like to switch the Dosing pump commands back to memory based but, again, have questions. I guess the big question is, is there an index or reference detailing the defined memory parameters? For instance, the parameters f...

rimai wrote:Send me a PM for RMA.

PM Sent.

I had to work late yesterday, but this morning before leaving for work, I set up the problem pump with the same tubing that I have on the one that works. I plugged it into a hot outlet to fill the tubing then plugged it into port 7. Immediately I could see that it was siphoning. There was a small ai...

Well, I've got "pump A" working on port 8 adding alk to my sump so, I'm going to leave that alone. I will continue to troubleshoot "pump B". I dissassembled the pumping head to inspect and didn't see anything of concern there. I was using some old tubing on it also. So, over the ...

I'd like you to use hard coded to make sure it is not some memory settings error. So, Try this code here: ReefAngel.DosingPumpRepeat(Port7,0,60,2); ReefAngel.DosingPumpRepeat(Port8,5,60,2); Can you visually see it?? I highly doubt that a peristaltic pump is siphoning. They are mechanically designed...

Siphon confirmed. I had two pumps so I programmed the second one on Port7. It performed normally while the original pump on Port8 continued to over-add. Just to be sure, I switched and put the problem pump on Port7 and the "good" one on Port8. The problem followed the pump. So, how do I go...

Well I tried the modification suggested above but got the same result. I set it for 2 seconds every 60 minutes with 5 minute offset. I was drawing off of a gallon jug 1/4 full of DI. I monitored the level and after 3 hours there was pretty much undectable drawdown, as you'd expect for only 6 seconds...

Thanks for the suggestion. I'll give it a try.

Hello all. I've done a lot of lurking, searching, and copying of code but this is my first post because I just don't have enough knowledge to figure this out. I'm struggling with programming my dosing pumps. I generated the first code for my RA using the wizard with the option where values are read ...