Reef Angel Forum

OK, thanks Lee. Had a problem with one of the boards so the build has been held up for a bit. Good to know though when the replacement gets here. I checked out your build, very nice! Your tapatalk large image links are broken, fyi.

The reason I would like to do this is because my 7-up ldd board only has one pwm ground input and 7positive inputs. I have two 7-up ldd boards used in part to control the 8 channels of lights. So I'm wondering if it would be safe to hook them up this way? Otherwise, how should I go about connecting ...

Thanks Lnevo, I'm not sure I explained it correctly. I have setup the dimming module with one ground to each ldd board. The module has a third ground port. My question is can I run the two negative outputs from the main unit to that third port? There is continuity between the three grounds on the mo...

Hi, I am setting up my Dimming Expansion Module (6 channels) and want to use at least one of the dimming channels on the main unit (for a max of 8 channels). My question is how do I go about grounding the two channels that come from the main unit. I currently have one of the grounds from the expansi...

Hi Roberto,
No, it does not. Only the green power light comes on and stays lit. No other lights flash or come on.

Alright so I just bought a used Reef Angel controller (I believe the Plus unit since it has a MEGA328P chip). When I first hooked it up everything seemed to be working fine with the pre-installed sketch; however it didn't know which outlet did what so I looked to reset it but couldn't connect to it ...

I imagine that this must have been mentioned before but the link to download the software is wrong. It reads www_reefangel_com/Download.ashx
but should be
www_reefangel_com/Download.asxp