Reef Angel Forum

Optiboot was the only one that would work when I wasn't having trouble uploading a couple days ago. After loading the small code and crazy amount of rebooting the controller I finally got it to finish uploading. I ordered the plus board Saturday so hopefully it fixes my problem and its not the cable...

A couple days ago I was uploading fine. Yesterday I tried to upload some new code the wizard made and was getting sync error. Today I am able to upload this code I found while searching about 90% of the time without errors. void setup () { Serial . begin (57600); Serial . println ( "Test" ...

I looked all over the store for a new one and I only saw the USB power cable. Is there replacements available? I think mine is bad. I just tried to upload new code and get a sync error. It worked 2 days ago when I set up my ato.

I am using the installer on the download page... If that is not the one I'm supposed to be using, can you please link me to the older version... Thanks in advance!!

Edit.... Found them after a few google hits.. Thanks again for the tip!!

I just received a reef angel used. I'm trying to restore the preloaded code to reset the unit. It always says code to big for reef angel with opti boot, however I did get the controller tester loaded with opti boot selected. With reef angel plus selected I get timeout error trying to load the same s...