Reef Angel Forum

could you link me to the location of the commands that would need to be sent?

If I try to make a simple GUI in visual studio do you think you could help me with info to finish it?

I actually have never programmed anything .net
I do have a copy of visual basic 2008 and started to try and learn it but never got time to try

I probably should have posted this in the requests section, if so please move it.

So i was trying to get the iphone app working without the wifi unit because my RA is hooked up to a computer, but had no luck. But, while i was trying to figure it out I realized that I had an extra touchsreen monitor laying around and wondered how hard would it be the create a graphical button type...

I will happily download the file from the link you sent if you can give me any idea what I need to do to use it. I am tech savvy, but when it comes to networking, ip addresses, port forwarding, etc... I'm a little lost

Is it possible to use the iPhone app without the wireless unit? I keep my reefangel connect to a laptop via the USB cable. The laptop is on my wifi network.

I have my ATO setup using the low ATO port, and I have two float switches wired in series, one is a fail safe. The problems that I use an aqualifeter pump and it is kind of slow, so I need to disable the ATO timeout because I need it to run longer than 255 seconds per hour. I have the interval set t...

OK, I have been trying this for hours with no luck. Last night I started compltelt from scratch with a fresh install of RA, RA Gen and got those two working fine. The arduino software is talking to the RA via COM11. When I set up the RA client I told it to also use COM11. When I run RA Client the bo...

I have had my RA for a few months, and haven't messed with it since I got it set up initially. I decided to try and connect to it to make some changes via the RA Gen. When I tried to upload the file to the board it seemed to be uploading ok, but when it completed I got a message that said "prob...