Reef Angel Forum

Things that have given me false PH levels in the past: 1. It was out of the water 2. Bad ATO float 3. Bad temp probe 4. Or sometimes the probe falls out of calibration or it just fails and I need to buy a new one. Today I am getting alerts my PH is 7.5. Time to start looking to see what's wrong in m...

Thank you binder. Looks great!

Outstanding! Thank you Curt

Thanks for the answer Roberto. Good to know

I also get the same error when using my ipad

I just recently been using an old iPhone as a monitor for my reef angel and have noticed every few minutes that I get an "Unable to retrieve data" error and I have to reload the page. Is this my wifi attatchment going bad or something else?
Thanks for any help

Curt this is great news. Looking forward to it. Thank you!

Thanks for the update. Really looking forward to using the app again

Oh ok. Thank you

What part is the function. Sorry for all the noob questions most of the time I feel so lost with this thing

Ok I'm confused. What do I add then if I want the reef crest mode?

Is the definition part everything between { } ?

ok Im a little lost. have had my WP40 cable for about a week and thought I would try to get my Jabao pump set up. If I understand it correctly all I have to do is add a code from page 1, of this topic, between the lines "Place your custom code below/above here" on my sketch. I can add this...

ok got the new cable and still not able to load a code. No red light flashing or anything

Ok sounds good. Welcome back

Looks fine as far as I can tell

On a reboot the red light does flash, but nothing when I connect the cable

By power cycle do you mean unplugging and plugging the reef angel?

When I get the upload error on Arduino it states the overriding baud rate is 115200. Is that right?

No no flashing at all

I'm able to use the cable to communicate with my wifi.

Yes. And it's working

Looked under device manager to make sure. Also just connected up my old board and couldn't connect to it also. Is their any way to check the USB-TTL CABLE?

Trying to upload a sketch and I'm getting an upload error. Reinstalled the Reefangel installer and it recognized the USB cable. It was working just last week. Here is what I got when I tried to upload: The following features were automatically added: Watchdog Timer Version Menu The following feature...

I had that relay running some extra lights I think. Can't remember now it's no longer in the cabinet

is it possible to change the date and time of your controller with the Iphone app?

Thank you I'll have to give that a try

How would I set a 30 sec delay for my skimmer to come on after I cancel the feed mode? When pumps are off for a water change or feed mode my sump fills and when I cancel mode the water line is too high for my skimmer and the collection cup fills up. I would like the skimmer to delay a little to give...

I didn't know that. Thank you

Was wondeing how often I should calibrate my PH probe?