
You will need to put a jumper across the ports that you want to change to Analog.
The jumpers are the same as you would put on a computer motherboard or hard drive.
When you open up the dimming module if you see the following...
![]() You will need to put a jumper across the ports that you want to change to Analog. The jumpers are the same as you would put on a computer motherboard or hard drive. |
|
Thanks
![]() Enviado desde mi GT-I9300 mediante Tapatalk |
|
ReefCrestMode is the default setting for the DC pump correct? And if I add ReefAngel.DCPump.UseMemory = true; I can set my pump from the portal or the RA Debug app in development. |
|
rimai, are there any I'll effects by removing both resistors and leaving the cap? |
|
Should be fine.
Roberto.
|
|
Actually, if you remove R1, the signal will never reach the pump. You must leave R1.
Roberto.
|
|
Can I substitute the 10k with a 1.8k? At 100% my wp10 doesn't seem to be pushing as hard.
|
|
The value won't affect the result, unless you increase to a really larger value, which would cause it to have slow response. You can even remove it and solder the pads together if you want to.
Roberto.
|
|
Thanks rimai. I'll just leave the 10k on R1 then. But other than that it works great using the ATO port.
|
|
Users browsing this forum: No registered users and 2 guests