DIY Skimmate Locker on the Cheap
16 posts
• Page 2 of 2 • 1, 2
I still haven't found a long stem float switch, but I've had one of these for a while, and if I silicone it in well it should do the trick. http://www.amazon.com/gp/product/B0076U ... UTF8&psc=1
|
|
nice. I've been wanting to put a reservoir signal in my top off water jug forever, but couldn't figure out how to get a long enough float towards the bottom of the reservoir. The silicone seal on the bottom makes me a bit nervous, but a tight seal with a layer of silicone should hold.
-Jon |
|
nice. I've been wanting to put a reservoir signal in my top off water jug forever, but couldn't figure out how to get a long enough float towards the bottom of the reservoir. The silicone seal on the bottom makes me a bit nervous, but a tight seal with a layer of silicone should hold.
-Jon |
|
I have the same container, but I am using it horizontally and punched holes through the white cap.
I will post a picture later. |
|
I haven't had to empty a full container yet, but I'm hoping to use the lever on the bottom.
Photo attached. ![]() Sent from my A0001 using Tapatalk Last edited by modulok on Sat Jun 18, 2016 6:12 am, edited 1 time in total.
|
|
Looks great!
|
|
16 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 1 guest