In moving my new computer last night, I accidentally plugged in the cable for my X10 setup before I was ready to install that software and it dropped a serial driver on top of my reef angel com4. Now I seem to be unable to remove that x10 driver (advice welcome) and wondering how easy it is to just change the com port of my reef angel.
thx in advance for all the help.
ross
changing com port
-
rossbryant1956
- Posts: 471
- Joined: Sat Jan 14, 2012 2:08 pm
- Location: Montgomery Village, MD
changing com port
Roscoe's Reefs - Starting Over Again:
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
Building new 29g Nano after landlord went berserk over my 4 75 gallon tanks, Multiple RA's, Water mixing stations, etc. Your help welcomed in remembering all I've forgotten.
Re: changing com port
Yeah, super easy.
Just open Arduino and change the the port on Tools->Serial Port
Just open Arduino and change the the port on Tools->Serial Port
Roberto.