New Replacement board

projectx · Post by **projectx** » Sat Apr 07, 2012 2:52 pm

The new replacement board that is on the site with more memory, does it have more memory than the controller that I purchased back in December?

projectx · Post by **projectx** » Sun Apr 08, 2012 10:03 am

The reason i ask is i am contemplating doing a DIY LED build, and I recently purchased a 2nd MP40 so was thinking about getting the RF module for the Vortechs. I am wondering if that is going to be exceeding the memory limits of the current board. I also currently have wireless and the dual dosing pump and my INO file is at 31300 of 32256

wolfador · Post by **wolfador** » Sun Apr 08, 2012 6:23 pm

That means you do not have the RA+, you can easily upgrade it. You should be able to do the LED's without it but would needs it for the RF module unless you cut some things from your current .ino

projectx · Post by **projectx** » Sun Apr 08, 2012 7:49 pm

I need to learn how to remove some of the graphics from the screen, im sure that would free up some space too. I will look at getting the upgrade

binder · Post by **binder** » Mon Apr 09, 2012 6:21 pm

to remove extra graphics from being displayed, uncheck the "display images" on the features tab in ragen and save the features file and re upload your code. that can save some space.

projectx · Post by **projectx** » Mon Apr 09, 2012 6:30 pm

Thanks for the tip, how would I remove it directly from the INO file?

Reef Angel Forum