Reef Angel Forum

Calibrate pH
This option is used to calibrate your pH probe.
To calibrate your pH probe, make sure to remove the storage bottle from the tip of the probe and rinse the probe with RO or distilled water.
pH 7.0 and pH 10.0 calibration solution, which are not provided, are necessary for the calibration process.
The numbers presented in this calibration process are not the actual pH reading. They are the raw numbers that the controller will use to calibrate your probe.
Dip the probe into the pH 7.0 calibration solution and let it stabilize. Optional: write down the number in the center between the pH 7.0 reading and the pH 10.0 reading.
Rinse the probe with RO or distilled water.
Dip the probe into the pH 10.0 calibration solution and let it stabilize. Optional: write down the number in the center between the pH 7.0 reading and the pH 10.0 reading.
After the reading stabilizes, navigate to the “Ok” button and press the joystick.
Navigating to the button “Cancel” and pressing the joystick will discard any changes.

#include <ReefAngel_Features.h>
#include <Globals.h>
#include <RA_Wifi.h>
#include <Wire.h>
#include <OneWire.h>
#include <Time.h>
#include <DS1307RTC.h>
#include <InternalEEPROM.h>
#include <RA_NokiaLCD.h>
#include <RA_ATO.h>
#include <RA_Joystick.h>
#include <LED.h>
#include <RA_TempSensor.h>
#include <Relay.h>
#include <RA_PWM.h>
#include <Timer.h>
#include <Memory.h>
#include <InternalEEPROM.h>
#include <RA_Colors.h>
#include <RA_CustomColors.h>
#include <AI.h>
#include <RF.h>
#include <IO.h>
#include <ORP.h>
#include <Salinity.h>
#include <PH.h>
#include <WaterLevel.h>
#include <ReefAngel.h>


////// Place global variable code below here


////// Place global variable code above here


void setup()
{
// This must be the first line
ReefAngel.Init(); //Initialize controller
   ReefAngel.WaterChangePorts= Port1Bit | Port2Bit | Port3Bit | Port5Bit | Port6Bit;

// Ports that are always on
ReefAngel.Relay.On(Port1);
ReefAngel.Relay.On(Port2);
ReefAngel.Relay.On(Port3);
ReefAngel.Relay.On(Port4);
////// Place additional initialization code below here


////// Place additional initialization code above here
}

void loop()
{
// Specific functions that use Internal Memory values
ReefAngel.Wavemaker(Port5,60);
ReefAngel.Wavemaker(Port6,120);
ReefAngel.StandardHeater(Port7,757,763);
ReefAngel.StandardLights(Port8,17,0,13,0);
////// Place your custom code below here


////// Place your custom code above here

// This should always be the last line
ReefAngel.ShowInterface();
}