Page 1 of 1
Help: my reef angel, stop working!!
Posted: Fri Mar 01, 2013 9:00 am
by stephy
Almost 1 hour ago I made few changes to vortech controls in my code. I uploaded the new code and all was fine for amost 10 minutes, then RA had a blank white screen flashing with green led always on and red one making 3 flash.
I tried to reset it to factory, but at the end of upload appeas a message: "An error has occured. Please try again."
Please, all my tank device word with RA...
Re: Help: my reef angel, stop working!!
Posted: Fri Mar 01, 2013 9:09 am
by rimai
What happens if you turn the power off and on again?
Re: Help: my reef angel, stop working!!
Posted: Fri Mar 01, 2013 9:19 am
by stephy
rimai wrote:What happens if you turn the power off and on again?
Sorry, I only powered off the controller, not the box. I powered all off and now it works again...
I was a little in panic before...sorry again...
Re: Help: my reef angel, stop working!!
Posted: Fri Mar 01, 2013 9:23 am
by DrewPalmer04
Hey, that's totally understandable!
Re: Help: my reef angel, stop working!!
Posted: Fri Mar 01, 2013 10:11 pm
by 00Warpig00
Just curious what makes that happen... I mean the fact that sometimes you can reset/reboot by pulling the VGA cable, other times you need to pull power to the relay box. Plugging the vga just continues to flash the white screen?
Nick
Re: Help: my reef angel, stop working!!
Posted: Sat Mar 02, 2013 1:24 pm
by stephy
00Warpig00 wrote:Just curious what makes that happen... I mean the fact that sometimes you can reset/reboot by pulling the VGA cable, other times you need to pull power to the relay box. Plugging the vga just continues to flash the white screen?
Nick
Yes, exactly.
Re: Help: my reef angel, stop working!!
Posted: Thu Mar 21, 2013 1:54 pm
by civictuner04
This is like what happens to mine we are trying something now do you have the wifi attachment