Page 1 of 1

ORP probe faulty?

Posted: Tue Aug 27, 2013 1:27 am
by butcherman
My ORP reads find on any reading below 325. at 325 it changes to 0 when ORP drops to below 325 it starts shoing reading again.

Im using 1.0.2 libraries and modified the libraries to calibrate with 220mv fluid.

when i recalibrate the terminator that came with the probe registers 1695
and the 220mv fluid reads 595

Is this the probe, hardaware or the code?

Re: ORP probe faulty?

Posted: Tue Aug 27, 2013 7:46 am
by rimai
Has it worked in the past?

Re: ORP probe faulty?

Posted: Thu Aug 29, 2013 8:17 am
by butcherman
Yes worked fine previously.

Sent from my GT-I9500 using Tapatalk 4

Re: ORP probe faulty?

Posted: Thu Aug 29, 2013 8:30 am
by rimai
1695 with the terminator sounds ok, but 595 for 220mV is too low.

Re: ORP probe faulty?

Posted: Thu Aug 29, 2013 12:22 pm
by butcherman
Probably best to replace

Sent from my GT-I9500 using Tapatalk 4