Page 1 of 1
Newbie Needing HELP!!
Posted: Sun Feb 19, 2012 8:20 am
by Saltydogg
Bear with me guys I am just getting started. I have Arduino installed and RAGen. When I opened RAGen and went through the steps as mentioned in the forum I am not seeing the Internal Memory Tab in order for me to setup my initial memory setting and upload it? Any suggestions.
Re: Newbie Needing HELP!!
Posted: Sun Feb 19, 2012 9:23 am
by binder
Controller Menu --> Internal Memory
It was moved and the documentation hasn't been updated yet.
Re: Newbie Needing HELP!!
Posted: Sun Feb 19, 2012 11:34 am
by Saltydogg
binder wrote:Controller Menu --> Internal Memory
It was moved and the documentation hasn't been updated yet.
Thanks for the help! Just ran into another setback...seems the ph probe was damaged at some point resulting in the glass bubble tip of the probe breaking off in the solution bottle the probe was packed in. Contacted Roberto and he is sending a new probe this week! Although I'm frustrated I am thankful for the exceptional Customer Service!! Thanks Reef Angel